Library

Portal to drilling documents and publications of interest to the ice drilling community. There are currently 514 documents in the Library.

Document Details

DEM modeling of ice cuttings transportation by electromechanical auger core drills
Authors: Hong J, Talalay P, Sysoev M, Fan X
Year: 2014
Keywords: ice coring
Periodical/Journal: Annals of Glaciology
Volume: 55
Number: 68
Page Range: 65-71
Abstract:

Electromechanical auger core drills are widely used in shallow ice-coring practice on mountain glaciers and polar ice caps and sheets. Generally, these drills are lightweight, can be readily transported to remote drilling sites, are easily installed there and drill with relatively high rates of penetration and low power consumption. During the past few decades, dozens of electromechanical auger drills have been designed. However, the auger options were usually determined by experience, and the main parameters (auger angle and rotation speed) are varied in a wide range from drill to drill. In order to choose the optimal auger parameters, the discrete element method (DEM) is used to analyze the performance of cuttings transportation for different rotation speeds in the range 50-200 rpm and auger angles in the range 15-45°. To improve the efficiency of cuttings transportation, many factors have to be considered (e.g. particle sizes and their variability, ice temperature, material of the core barrel and jacket, and availability of needed driven motor-gears). For the conditions assumed in the present studies, the recommended rotation speed is 100 rpm at auger angles of 35-40°.

DOI: 10.3189/2014AoG68A002
URL: View document